• 1-888-691-1333

How to Hire CDL Drivers for Your Septic Pumping Business

Key takeaways

  • Check each truck’s GVWR: 26,001 pounds or more means a CDL, and a tank of 1,000 gallons or more usually means the tanker (N) endorsement too.
  • A non-CDL truck in your fleet lets you hire and train good people before they’re licensed.
  • Honest job posts and a paid ride-along filter out drivers who won’t last.
  • Run the checks DOT already requires (driving record, Clearinghouse query, drug test, medical card) before you make an offer.
  • Train new drivers on the vacuum system and safety over 2 to 4 weeks, along with the road.

A pump truck sitting in the yard because you can’t staff it is one of the most expensive problems in a septic business. And the bigger the truck, the harder the seat is to fill. Experienced drivers for tandem and tri-axle vacuum trucks are hard to find, and they know it.

This is a practical playbook for hiring CDL drivers, from checking which trucks need a license to the day a new driver runs a route alone.

Know which of your trucks need a CDL

Start with your own fleet. The license a driver needs depends on the truck, not the job title.

  • Class B CDL: required for a straight truck with a gross vehicle weight rating (GVWR) of 26,001 pounds or more. Many septic pump trucks fall here.
  • Class A CDL: required for a combination over 26,001 pounds when the towed unit is over 10,000 pounds, like a pump truck pulling a pup trailer or a tractor pulling a vacuum tanker.
  • Tanker (N) endorsement: federal rules treat a vehicle as a tank vehicle when it carries liquid in a tank of more than 119 gallons and 1,000 gallons or more in total. A CDL septic truck almost always carries well over 1,000 gallons, so plan on requiring the N endorsement.

Your trucks fall into rough tiers. Pickups with slide-in tanks and some single-axle trucks sit under the CDL line. Single-axle trucks in the 1,800 to 2,800 gallon range often sit close to it. Tandem and multi-axle trucks carrying 3,000 gallons or more need a CDL.

Check the GVWR on the door-jamb sticker, not the tank size. And check your state, since some add their own rules. A CDL is also separate from the permit your business holds to pump and haul septage.

One more thing to consider: a non-CDL truck in your fleet is a hiring tool. It lets you bring on someone good before they’re licensed and train them up.

Decide who you’re hiring

You have two paths.

Hire an experienced CDL driver. Faster to get on the road, but you’re competing with every trucking company in your area for the same people.

Hire for attitude and sponsor the CDL. You get someone you picked for reliability and work ethic, and you train them your way. Budget the time: since February 7, 2022, first-time Class A and Class B applicants must complete Entry-Level Driver Training from a provider on FMCSA’s Training Provider Registry before taking the skills test.

Many operators do both. They keep one or two experienced drivers on the big trucks and grow new hires on the smaller ones.

Write a job post that tells the truth

The fastest way to lose a new driver is to surprise them. Put the real job in the post:

  • Digging to tank lids, dragging heavy hose, and working outside in every kind of weather
  • The smells, and the occasional spray
  • Backing a loaded truck into tight driveways and down camp roads
  • Talking with homeowners who have a lot of questions

Then list the requirements plainly: CDL class, N endorsement, clean driving record. Add the schedule, the trucks they’ll drive, and the training you provide. If you have a pay range, include it. Honest posts get fewer applicants and better ones.

Where to find septic CDL drivers

  • Indeed and ZipRecruiter. Where most operators start, and still the biggest pool.
  • Facebook and local groups. Good for reaching people who aren’t actively looking.
  • Employee referrals. Pay a bonus once the new hire has stayed 90 days.
  • Local CDL schools. Students need jobs, and some need a sponsor.
  • Veterans. Many come out of the military with heavy-vehicle experience and strong habits.
  • Temp agencies. Useful for a busy season while you look for the long-term hire.

Screen with the checks DOT already requires

Before you make an offer, run the checks the rules already call for:

  1. Motor vehicle record. Also confirms they can be insured on your policy.
  2. Drug and Alcohol Clearinghouse query. Required before a new CDL driver operates a commercial vehicle for you.
  3. Pre-employment drug test.
  4. A valid DOT medical card.
  5. Safety history from previous employers, and references.

Then book a paid ride-along. Half a day on a real route shows the candidate the work, and shows you how they handle it, before either of you has invested in training.

Interview questions that fit septic work

General driving questions only get you so far. Add a few that test for the job itself:

  • Tell me about the tightest spot you’ve backed a loaded truck into.
  • Have you run a PTO-driven vacuum pump? What do you check before you start?
  • The vacuum gauge usually reads 22 inches and today it reads 18. What might be going on?
  • A homeowner asks why their drain field is soggy. What do you say?
  • What would you do if septage spilled in a customer’s driveway?

Listen for honesty as much as the answer. “I don’t know, I’d call the office” is a good answer from a new driver.

Train them in 2 to 4 weeks

Write your training down, and use it for every hire.

Week 1: safety and the truck. Protective gear, keeping hands dry, and eye protection. Vaccinations to discuss with a doctor. Sewer gas hazards. Chocking wheels while the PTO runs. Never entering a tank, which is OSHA confined-space work. Then the vacuum system: primary and secondary shutoffs, the vacuum and pressure relief valves, the gauge, and the lever positions. Follow your pump manufacturer’s manual for settings and limits. Finish with daily checks such as pump oil, draining the secondary trap, and the oil catch.

Week 2: ride with a lead driver. The new hire watches, then helps, on real jobs. Include how you run the software in the field.

Weeks 3 and 4: they drive, the lead rides. Every truck is built a little differently, so they learn yours.

Keep the drivers you hire

Hiring is half the job. Keeping good drivers comes down to a few things: reliable trucks, fair pay, and a day that doesn’t end with paperwork.

That last one is where software helps. With ServiceCore’s driver app, drivers get turn-by-turn directions and see the job details before they arrive, including lid depth, hose length and access notes. They record gallons, take photos and collect payment on site, so nothing is left to fill out at night. On the office side, Monson Septic & Portable Restrooms cut route planning from more than 4 hours to 5 minutes.

If you’re still sizing up the fleet, see what a septic truck costs before you add a truck you’ll need to staff. If you’re comparing systems for your drivers, compare the software options or compare ServiceCore and Summit head to head.

FAQs

Do septic pump truck drivers need a CDL?

It depends on the truck. Federal rules require a Class B CDL for a straight truck with a GVWR of 26,001 pounds or more, and a Class A for heavier combinations like a truck pulling a trailer. Many smaller single-axle and slide-in units fall under the line. Check the door-jamb sticker and your state’s rules.

Do septic truck drivers need a tanker endorsement?

Usually. A vehicle counts as a tank vehicle when it carries liquid in a tank of more than 119 gallons and 1,000 gallons or more in total. Most CDL septic trucks carry well over that, so the N endorsement is typically required.

Can I hire a driver without a CDL and train them?

Yes. Many operators start new hires on a non-CDL truck and sponsor their CDL. Since February 2022, first-time Class A and B applicants must complete Entry-Level Driver Training from a registered provider before the skills test, so plan for that time.

What checks are required when hiring a CDL driver?

At a minimum, a motor vehicle record, a pre-employment query of the FMCSA Drug and Alcohol Clearinghouse, a pre-employment drug test, and a valid DOT medical card. Previous employers’ safety history and references round it out.

How long should training take for a new septic driver?

Two to four weeks works for most operators: a week on safety and the truck, a week riding with a lead driver, then a week or two driving with the lead riding along.

Where do septic companies find CDL drivers?

Indeed and ZipRecruiter are the most common. Employee referrals with a 90-day bonus, local CDL schools, veterans and temp agencies are all worth adding.

Want to see what your drivers would use every day? Book a demo.

Matt Aiello

Matt Aiello

Chief Marketing Officer, ServiceCore | Docket

Matt Aiello is a seasoned marketing executive with over two decades of experience driving growth for B2B software companies. As VP of Marketing at ServiceCore and Docket, he leads the strategy behind the software solutions trusted by thousands of portable toilet and dumpster rental businesses across the U.S. Matt’s team focuses on building tools and content that help haulers streamline operations, increase efficiency, and grow smarter. Before joining ServiceCore, Matt led marketing for a portfolio of SaaS companies at EverCommerce for blue collar service industries.

[post_nav]
Go to Top